BW Technologies MicroClip XT Spezifikationen PDF herunterladen (Seite 58)

GasAlertMicroClip XT

Maintenance

Battery Cautions

a Warning

To avoid personal injury and/or property damage, adhere to

the following:

• The detector must be deactivated to charge the battery.

• Charge the battery immediately when the detector emits a low

battery alarm. Refer to Charging the Battery

• Charge the battery in a safe area that is free of hazardous gas

in temperatures of 32°F to 113°F (0°C to 45°C).

• Charge the battery using the BW Multi-Unit Cradle Charger or

charger adapter only. Do not use any other charging adapters.

Failure to adhere to this caution can lead to fire and/or explo-

sion.

• The charging adapter is voltage specific to your region. Use of

the charging adapter outside your region will damage the

charger and the detector.

• Do not calibrate the detector during or immediately after

charging the battery.

• The battery can only be replaced by the manufacturer. Failure

to adhere to this caution can lead to fire and/or explosion.

• Warning: The GasAlertMicroClip XT uses a lithium battery that

may present a risk of fire or chemical burn hazard if misused.

Do not disassemble, heat above 212° (100°C), or incinerate.

• Warning: Lithium polymer cells exposed to heat at 266°F

(130°C) for 10 minutes can cause fire and/or explosion.

Charging the Battery

To charge the battery, refer to Figure 10., Table 12., and the following

procedures (1-8).

Figure 10. Connecting the Charging Adapter

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 73 74

Keine Kommentare

BW Technologies MicroClip XT Spezifikationen Seite 58