BW Technologies MicroClip XT Betreibershandbuch PDF herunterladen (Seite 18)

GasAlertMicroClip XT

Operator’s Manual

Replacing the sensor filter

1. Note the placement of the PCB to ensure it is

replaced correctly. Remove the two screws on the

PCB. Remove the PCB carefully.

Caution

Ensure no damage occurs to the battery.

2. Remove the old sensor filter. It may be stuck to the

sensors.

3. Place the new sensor filter.

Note

When inserting a new sensor filter, ensure the black

gasket is facing the front shell.

4. To complete the detector, refer to Reassembling the

detector.

Replacing H

S, CO, and LEL sensor

1. Note the placement of the PCB to ensure it is

replaced correctly. Remove the two screws on the

PCB. Remove the PCB carefully.

Caution

Ensure no damage occurs to the battery.

If the sensor filter is stuck to the sensors, remove and

replace the sensor filter into the front shell.

2. Slide the sensors out.

Note

Detectors that are configured for 1, 2, or 3 gases may

contain a dummy sensor in one of the four sensor

locations.

3. Insert the new sensor(s).

4. To complete the detector, refer to Reassembling the

detector.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23

Keine Kommentare

BW Technologies MicroClip XT Betreibershandbuch Seite 18